![]() ![]() Remove the black back cover of the alarm clock by gently pulling upward being careful not to disconnect the wires which are attached to the back cover. Remove the three small silver screws located at the top and both sides of the back cover using the #1 Phillips screwdriver which is in the iFixit toolkit. Repeat the above steps in reverse order to reassemble the alarm clock.įollow these directions to secure your alarm clock hands: Detach the yellow wires that connect the wiring to the battery compartment and the copper cylinder by using a soldering iron.įor access and replacement of the alarm wiring box, follow this step-by-step replacement guide with photographs:Įquity Alarm Clock 13014 Alarm Replacement Gently remove the wiring box by gently lifting upward. Using the spudger ,which is provided in the iFixit toolkit, or a prying tool, insert the flat end of the spudger on both sides of the wiring box to open and detach the box from the clock's main component. Locate the alarm the wiring box which is identified as an opaque wiring box. ![]() ![]() Using the #1 Phillips screwdriver, replace the three small silver screws on the back cover.įollow these directions to replace the alarm wiring box: Line up the screw holes with the holes on the black cover. Replace the black back cover of the alarm clock by gently placing it within the gold metal casing of the alarm clock. Using the #1 Phillips screwdriver, replace the two small silver screws located on the top and bottom of the alarm switch. See the following alarm switch replacement guide for step-by-step instructions with photographs:Įquity Alarm Clock 13014 Alarm Switch Replacement After detaching the wires from the alarm switch box, replace the alarm switch with your new replacement alarm switch by reversing the previous steps. Using a soldering iron, detach yellow wire end from the copper cylinder component by placing the end of the soldering iron to the bare end of the wire. Using the #1 Phillips screwdriver, remove the two small silver screws located at the top and bottom of the alarm switch. Remove (1) "AA" battery from the battery compartment. Using a standard flat head screwdriver, remove the black battery compartment cover, which is located on the back of the alarm clock towards the bottom between the alarm clock legs by lifting gently on tab with the screwdriver. Follow these directions on replacing the alarm switch: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |